Page 1 of 1
Singh grooves?
Posted: Thu Mar 30, 2023 1:10 pm
by spl310
Has anyone put Singh grooves in their cylinder heads? Any research into them? They sound intriguing.
Re: Singh grooves?
Posted: Thu Mar 30, 2023 4:07 pm
by 23yrRebuild
Hey Sid,
You might have already checked these out, but I searched and found these past, 311s posts regarding Singh grooves....they do sound intriguing...I'd like to know more too..
search.php?keywords=Singh
Re: Singh grooves?
Posted: Thu Mar 30, 2023 6:46 pm
by redroadster
Sounds like Mitsubishi s Jet valve 2.6L hemi engine ....fiasco , designed to stir the combustion chamber gases
It used to leave the nail sized valve down and the piston would shoot the valve stem thru the VC then the hood .( training staff spoke of it being a presentation to Goverments as a emmissions break thru )
You realize the best synario performance wise is to get as much raw fuel into the cyl the intake valve face eats that up. And every thing the fuel touches too Manuf. Perf engineers, would be all over it if ,
It was a big deal ,with no down side
Re: Singh grooves?
Posted: Thu Mar 30, 2023 8:25 pm
by spl310
I didn't search, but did ask about it a long time ago. I was wondering if any of the current members had tried them.