Datsun Roadster Floor Pans

[TJFLY]

The complete floor pan covers all of the floor except for the sloped portion where a roll bar would mount. It does cover the area on either side of the sloped area . Not a patch . Thanks

[Hialeah_Datsun]

How do I contact you to place an order?

[TJFLY]

Contact info was sent to your PM box. Thanks.

[SPLutah]

Sorry about the delay. The parcel shelf has very little vertical other than the turned lip around the edge. The trunk is much more involved. My car is a 68. Happy to send pictures if needed.

[TJFLY]

No worries. That turned up portion is actually a brace that the shelf sits on and is spot welded to.I should have the shelf finished some time tomorrow and will post a picture. Sure please send me a picture of your trunk and shelf when you have the time. Thanks

[Mustninty]

Im also looking for a full floor, from firewall to the shelf in the back. Please send me a message with the details, ty.

[BAMUZ]

Datsun roadster floor pans for sale. I will be making left and right quarters and halves in a limited run. Quarters are $200 and halves are $425. Floor pans are hand made from 18 gauge cold rolled steel and extend from the floor to the lower part of the transmission tunnel. First ten orders receive free, yes free ground shipping in the lower U.S. 48 states. Hawaii, Alaska, U.S. territories, and International countries, shipping is still 100% available but rates will vary depending on location. Thanks and keep those Roadsters going.

Pm’d