Page 1 of 1
Paint or powder coat?
Posted: Tue Dec 03, 2019 9:24 pm
by Jdflyer
Just cleaned up the crank pulley and would like to know everyone’s thoughts on best way to finish.
If paint is there a type I should use?
Will the rubber last in a pc oven?
AAD367EE-7981-4834-A95F-DBDA611B6F1D.jpeg
0720E46A-18B3-407E-B0E5-94DCB30E0E93.jpeg
Re: Paint or powder coat?
Posted: Tue Dec 03, 2019 10:57 pm
by C.Costine
I primed mine with epoxy primer and top-coated with black Rustoleum with a little hardener in it to make it durable. I did it along with a number of other pieces at the same time.
Re: Paint or powder coat?
Posted: Wed Dec 04, 2019 12:44 am
by spriso
We always paint crank pulleys— and then add the timing marks back with a little model paint.
Michael
Re: Paint or powder coat?
Posted: Wed Dec 04, 2019 1:22 am
by Mattk
I’m going with paint for fear I might damage the rubber.
$0.02
Matthew