Refurbishing "Pearl"

eye · Post by **eye** » Tue Oct 29, 2019 7:17 am

Hello
Been on the site for a while and saving wheeled vehicles from dumpsters for decades. Inherited "Pearl" for doing some work I did on a 63 single carb 1500 that a friend owned.
"Pearl" needs some love.Ok, a lot of love.
Too far gone to restore so I am building a hot rod and still keeping it on the road. SR20 Borg Warner turbo with 5 speed, big brakes, Ford 8.8 rear, etc..
Thanks for the site and all the info.
Anybody else in NC?

s15to311 · Post by **s15to311** » Tue Oct 29, 2019 8:09 am

After seeing your last project, I'm super interested to see where you go with this! Sorry I wasn't in the office when you stopped by.

eye · Post by **eye** » Tue Oct 29, 2019 9:42 am

It will be nothing as sweet as the one you are building!
Thanks again for the goodies.
J

eye · Post by **eye** » Tue Oct 29, 2019 9:48 am

She already has been hit with the cutoff wheel and welder a bit. The inner fender cutouts are for the intercooler piping and the firewall cutout is for the battery. Wilwood swing pedals up inside under the dash.

Post by **notoptoy** » Tue Oct 29, 2019 7:58 pm

There are quite a few of us in NC, whereabouts you located?

Datsun Roadster Forum-311s.org

Refurbishing "Pearl"

Refurbishing "Pearl"

Re: Refurbishing "Pearl"

Re: Refurbishing "Pearl"

Re: Refurbishing "Pearl"

Re: Refurbishing "Pearl"