Wing Nut Remover/Installer Mod
Posted: Fri Mar 30, 2018 12:18 pm
As MANY of us (especially Lorna C. - G) have experienced, getting to those pesky wingnuts behind the gauges can be a PITA. (whether the dash is in OR out of the car)
[attachment=1]20180327_200638[1].jpg[/attachment]
This 'tip' involves cutting a groove in a bolt of suitable length that will allow the wingnut 'wings' to be captured in the groove.
#1
[attachment=2]20180327_200658[1].jpg[/attachment]
Additionally, you have to use a drill bit, smaller than the diameter of the nut to drill a small hole so that the 'crown' of the nut will fit into it. #2
#2[attachment=2]20180327_200658[1].jpg[/attachment]
Wing nut 'embraced' by bolt
[attachment=1]20180327_200638[1].jpg[/attachment]
This 'tip' involves cutting a groove in a bolt of suitable length that will allow the wingnut 'wings' to be captured in the groove.
#1
[attachment=2]20180327_200658[1].jpg[/attachment]
Additionally, you have to use a drill bit, smaller than the diameter of the nut to drill a small hole so that the 'crown' of the nut will fit into it. #2
#2[attachment=2]20180327_200658[1].jpg[/attachment]
Wing nut 'embraced' by bolt