Worm gear for a 68 2000
Moderators: notoptoy, S Allen, Solex68
-
ttyR2
- Roadster Fanatic
- Posts: 386
- Joined: Sat Jun 06, 2009 6:58 pm
- Location: Athena, OR
- Contact:
Re: Worm gear for a 68 2000
Is the problem with the splines? If so, a good machine shop should be able to open the bore up a bit and run a spline broach through it to fix the issue. That assumes that the u-joint can be disassembled like on a driveshaft.
Jeremy
1964 Datsun 1500 SPL310
now sporting a '67 R-16 and 5-speed
1964 Datsun 1500 SPL310
now sporting a '67 R-16 and 5-speed
-
23yrRebuild
- Roadster Fanatic-Site Supporter
- Posts: 1075
- Joined: Sat Oct 25, 2003 2:19 pm
- Location: 3rd rock from the sun
- Model: 1500/1600
- Year: Low Windshield-64-67.5
Re: Worm gear for a 68 2000
Borgeson has one that's just a few thousandths off the metric spline specs, too bad.
Mike - '67 Stroker / 5-Speed
-
Linda
- Fraternal Den Mother-RIP
- Posts: 7807
- Joined: Sat Nov 05, 2005 11:37 pm
- Location: Los Angeles
- Model: 1500/1600
- Year: High Windshield-68-70
Re: Worm gear for a 68 2000
This is going to be a real problem one day as there are only so many late boxes around, and I don't see them too often on EBAY.
Wish someone would get them made, or figure out a rehab fix.
Linda
Wish someone would get them made, or figure out a rehab fix.
Linda
Sadly-Linda has passed away 2022. She was the 311's den mother and drove the first Rare-Parts ball joint project. RIP.
-
Ted928
- Roadster Fanatic-Site Supporter
- Posts: 131
- Joined: Sun Jun 20, 2004 10:21 pm
- Location: Charlton, NY