Datsun Roadster Forum-311s.org

redroadster68 wrote: ↑Wed May 26, 2021 6:14 pm Alvin do you ever scrape tire on fender lip over compression bumps or hard cornering. Not a lot of clearance in pics . Thanks

Great question. It does not rub because of the alignment (-1.75 degrees camber) and overall tire diameter.

Here is a picture from the Corkscrew at Laguna Seca under full compression while turning:



Pre-alignment it would rub on really hard left-hand turns under full compression. A good test (without causing too much damage) is a decent driveway entry...drive up/down at a severe angle and turn the wheel to see if it rubs the fender lip.

That #2 suspiciously looks like a "Z". Hmmm
.
Great photo.

Solex68 wrote: ↑Wed May 26, 2021 7:41 pm That #2 suspiciously looks like a "Z". Hmmm
.
Great photo.

AbZolutely!

This is what happens when you run with the Z car crowd

Great...thanks. Great pic

10 months. About 7400 miles.
Really like these tires. Lots of grip for canyon runs.